-
UKAEA-CCFE-PR(23)1212023
In the paper we present an overview of interpretive modelling of a database of JET-ILW 2021 D-T discharges using the TRANSP code. Our main aim is to assess our capability of computationally reproducing the fusion performance of various D-T plasma scenarios using different external heating and D-T mixtures, and understand the performance driving mec…
-
UKAEA-CCFE-PR(23)132023
Following the first Deuterium-Tritium Experiment (DTE1) at UKAEA, modifications were investigated to the Joint European Torus’ (JET) gas introduction systems to increase the gas feed capabilities of the JET facility to better support future campaigns. The gas introduction systems comprise the gas introduction and gas distribution system (GI/GD)…
-
UKAEA-CCFE-CP(23)542022
Several Ion Cyclotron Resonance Heating (ICRH) schemes in DT plasma have been considered for the ITER reactor [1]. Most of these heating schemes are minority heating at fundamental frequency. In DT plasma, both reactants can also absorb RF power as majorities at fundamental n=1 or harmonic n=2 frequency. Understanding benefits of directly heatin…
-
UKAEA-CCFE-PR(22)312022
Unusually high power loads on the Beryllium limiter caused by Neutral Beam re-ionisation, and much cooler divertor target surfaces were observed during the recent JET tritium campaign. As both phenomena are driven by scrape-off layer (SOL) physics, the SOL features of 72 tritium H-mode discharges and their deuterium references have been studied. …
-
UKAEA-CCFE-CP(23)392021
A key aim of the 2021 JET deuterium-tritium (D-T) experiments was to demonstrate steady high fusion power (10-15MW) with the ITER-like Be/W first wall. Plasmas were developed using D, repeated with T to investigate and mitigate isotope effects, and run with D-T to maximise fusion power. Compared with high current (q95~3) ‘baseline’ plasmas, …
-
UKAEA-CCFE-CP(23)352021
Neutral Beam Injection (NBI) is a very flexible auxiliary heating method for tokamak plasmas, capable of being efficiently coupled to the various plasma configurations required in the Tritium and Deuterium–Tritium Experimental campaign (DTE2) to be undertaken in the JET device. In particular, experiments for high fusion yield and alpha particl…
-
UKAEA-CCFE-PR(23)952021
The experimental observation of multiple oscillations likely associated with beta-induced Alfven eigenmodes with toroidal mode number n = 1, 2 during strong tearing activity in JET plasmas is reported in this work. It is found the frequencies of these oscillations range from 5 kHz to 20 kHz, being consistent with the low-frequency beta-induc…
-
UKAEA-CCFE-PR(21)832021
This Review considers current Zr alloys and opportunities for advanced zirconium alloys to meet the demands of a structural material in fusion reactors. Zr based materials in the breeder blanket offer the potential to increase the tritium breeding ratio above that of Fe, Si and V based materials. Current commercial Zr alloys might be considered …
-
UKAEA-CCFE-PR(21)242021
Small Angle Neutron Scattering (SANS) is performed to analyse the microstructural state of reference CuCrZr material with carefully controlled heat treatments, small-scale manufacturing mock-ups of assemblies and high-heat-flux exposed mock-ups. The information derived from the SANS data corresponds well to existing literature data based on microsc…
-
UKAEA-CCFE-CP(23)112020
Dimensionless experiments test the invariance of plasma physics to changes in the dimensional plasma parameters, when the canonical dimensionless parameters are conserved [1], [2]. Isotope identity experiments exploit the change in isotope ion mass A = mi/mp to obtain plasmas with identical dimensionless profiles in the same tokamak. However, condi…
Showing 11 - 20 of 58 UKAEA Paper Results