-
UKAEA-CCFE-PR(23)1372022
The International Thermonuclear Experimental Reactor (ITER) is an international nuclear fusion research and engineering project with the aim to prove the feasibility of nuclear fusion as a large-scale carbon-free source of energy. The reactor vessel contains several diagnostic windows that provide a line of sight to the plasma. Design and qualif…
-
UKAEA-CCFE-PR(23)1432023
Due to the strong rate dependence in their mechanical response, polymers find widespread use in applications subject to impact loading. However, characterizing these materials on microsecond time scales has proven challenging. Traditional experimental techniques rely on satisfying a number of limiting assumptions and typically do not provide direct…
-
UKAEA-CCFE-PR(23)1752022
In-vessel plasma facing components in fusion reactors such as ITER and DEMO experience high thermal loads and require active cooling, for which water is one possible coolant. The solution where plasma facing components utilise tungsten blocks as sacrificial armour has a joint internal structure of cooling tubes made from the copper base (~99% Cu…
-
UKAEA-CCFE-PR(23)1742022
Understanding the effects of interfacial micro-structures/-defects such as voids, grain boundaries (GB) and partial recrystallization (Rx) is critical to achieving superior mechanical properties for safety-critical parts. These features may appear during advanced manufacturing processes such as sintering, additive manufacturing (AM), and diffusi…
-
UKAEA-CCFE-PR(23)1512023
Multiphase Fe-based hardfacing alloys, for example Tristelle 5183 Fe-21%Cr-10%Ni7.5%Nb-5%Si-2%C in wt.%, are extensively used for tribological applications, including valves, bearings and drive mechanisms, where two surfaces are unavoidably subjected to loaded sliding contact within engineering systems. In this study, transmission electron microsco…
-
UKAEA-CCFE-PR(23)1562023
Heat sinks have manifold applications, from micro-electronics to nuclear fusion reactors. Their performance expectations will continue to increase in line with the power consumption and miniaturisation of technology. Additive manufacturing enables the creation of novel, compact heat sinks with greater surface-to-volume ratios and geometrical comple…
-
UKAEA-CCFE-PR(23)1492022
Materials subjected to irradiation damage often undergo local changes in the microstructure that effect the expected performance. To investigate those changes, this work proposes a novel approach to detect strain localisation caused by irradiation-induced damage in nuclear materials on the microstructural level, conside…
-
UKAEA-CCFE-PR(23)1422023
A Supervised Parallel Optimisation (SPO) is presented. The proposed framework couples different optimisation algorithms to solve single-objective optimisation problems. The supervision balances the exploration and exploitation capabilities of the distinct optimisers included, providing a general framework to solve problems with diverse character…
-
UKAEA-CCFE-CP(23)652022
The CHIMERA fusion technology test facility is currently under construction at the UK Atomic Energy Authority site in South Yorkshire, UK. With the completion of the engineering design, including the design of a component mock-up to be used in full system commissioning, this paper presents in detail the features and capabilities of the CHIMERA faci…
-
UKAEA-CCFE-PR(23)1682023
Wide-spread availability of low-cost digital sensors has made the acquisition of full-field experimental measurements less challenging, with modern measurement systems capable of obtaining three dimensional (3D) data fields. This presents difficulties when comparing computational and co…
Showing 21 - 30 of 179 UKAEA Paper Results