UKAEA Journals

Showing 1 - 7 of 7 Journals Results
2016
CCFE-PR(16)18

A subset of JET ITER-like wall (ILW) discharges, combining electron density and temperature as well as divertor heat flux measurements, has been collected for the validation of non-linear MHD simulations of Edge-Localised-Modes (ELMs). This permits a quantitative comparison of simulation results against experiments, which is required for the valida…

Preprint Published
2015
CCFE-PR(15)11

Sustained Edge Localised Mode (ELM) mitigation has been achieved on MAST and AUG using RMPs with various toroidal mode numbers over a wide range of low to medium collisionality discharges. The ELM energy loss and peak heat loads at the divertor targets have been reduced. The ELM mitigation phase is typically associated with a drop in plasma density…

Preprint Published
2015
CCFE-PR(15)111

Recent studies dedicated to the characterisation of in-vessel dust in JET with the new ITER-like wall (ILW) show that dust levels are orders of magnitude lower compared with the latter stages of the carbon-wall (CW) period and are decreasing with operational time. Less than 1 g of dust was recovered in a recent inspection, compared with more than 2…

Preprint Published
2014

The ITER-like wall (ILW) at JET is a unique opportunity to study the combination of material (beryllium and tungsten) that will be used for the plasma facing components (PFC) in ITER. Both the limiters (Be) and divertor (CFC W coated and bulk W) have been designed to maximise their power handling capability. During the last experimental campaign (O…

Published
2013

One of the main approaches to thermonuclear fusion relies on confining high temperature plasmas with properly shaped magnetic fields. The determination of the magnetic topology is, therefore, essential for controlling the experiments and for achieving the required performance. In Tokamaks, the reconstruction of the fields is typically formulated as…

Published
2012

For the new ITER-like wall at JET, two new infrared diagnostics (KL9B, KL3B) have been installed. These diagnostics can operate between 3.5 and 5 µ m and up to sampling frequencies of ~ 20 kHz. KL9B and KL3B image the horizontal and vertical tiles of the divertor. The divertor tiles are tungsten coated carbon fiber composite except the central til…

Published