UKAEA Journals

Showing 1 - 10 of 37 Journals Results
2015
CCFE-PR(15)111

Recent studies dedicated to the characterisation of in-vessel dust in JET with the new ITER-like wall (ILW) show that dust levels are orders of magnitude lower compared with the latter stages of the carbon-wall (CW) period and are decreasing with operational time. Less than 1 g of dust was recovered in a recent inspection, compared with more than 2…

Preprint Published
2015
CCFE-PR(17)16

Recent JET-ILW [1,2] experiments reiterated the importance of tuning the plasma fuelling in order to optimize ion cyclotron resonance frequency (ICRF) heating in high power H-mode discharges. By fuelling the plasma from gas injection modules (GIMs) located in the midplane and on the top of the machine instead of adopting the more standardly used di…

Preprint Published
2015
CCFE-PR(15)26

A discrepancy in the divertor radiated powers between EDGE2D-EIRENE simulations, both with and without drifts, and JET-ILW experiments employing a set of NBI-heated L-mode discharges with step-wise density variation is investigated. Results from a VUV/visible poloidally scanning spectrometer are used together with bolometric measurements to determi…

Preprint Published
2015
CCFE-PR(15)25

A set of Be and W tiles removed after the first ITER-like Wall campaigns (JET-ILW) from 2011-2012 has been analysed. The results indicate that the primary erosion site is in the main chamber (Be) as in previous carbon campaigns (JET-C). In particular the limiters tiles near the mid-plane are eroded probably during the limiter phases of discharges. …

Preprint Published
2015
CCFE-PR(15)21

Selected Ion Beam Analysis techniques applicable for detecting deuterium and heavier impurities have been used in the post-mortem analyses of tiles removed after the first JET ITER-Like Wall (JET-ILW) campaign. Over half of the retained fuel was measured in the divertor region. The highest figures for fuel retention were obtained from regions with …

Preprint Published
2015
CCFE-PR(15)19

Rotating collectors are used in JET to provide time-resolved measurements of erosion and redeposition of vessel materials. The silicon collecting disks rotate behind an aperture, driven by pulsing of the toroidal magnetic field, with the deposits analysed ex-situ by Nuclear Reaction Analysis. The angular dependence of deposition is mapped to discha…

Preprint Published
2015
CCFE-PR(15)128

The influence of the ITER-like Wall (ILW) with divertor target plate made of tungsten (W), on plasma performance in JET H-mode is being investigated since 2011 (see [1] and references therein). One of the key issues in discharges with low level of D fuelling is observed accumulation of W in the plasma core, which leads to a reduction in plasma perf…

Preprint Published
2015
CCFE-PR(15)115

We present the application of an improved EDGE2D-EIRENE SOL transport model for the ELM phase utilizing kinetic correction of the sheath-heat-transmission coefficients and heat-flux-limiting factors used in fluid SOL modelling. With a statistical analysis over a range of similar Type-I ELMy H-mode discharges performed at the end of the first JET IT…

Preprint Published
2014

In this work we estimate the fuel ion density profile in deuterium plasmas at JET, using the JET neutron camera, the neutron time-of-flight spectrometer TOFOR, and fusion reactivities modeled by the transport code TRANSP. The framework has been tested using synthetic data, which showed that the density profile could be reconstructed with an average…

Published
2014

First simultaneous measurements of deuterium-deuterium (DD) and deuterium-tritium neutrons from deuterium plasmas using a Single crystal Diamond Detector are presented in this paper. The measurements were performed at JET with a dedicated electronic chain that combined high count rate capabilities and high energy resolution. The deposited energy sp…

Published