UKAEA Journals

Showing 1 - 7 of 7 Journals Results
2021
UKAEA-CCFE-PR(21)26

The first divertor was installed in the JET machine between 1992 and 1994 and was operated with carbon tiles and then beryllium tiles in 1994-5. Post-mortem studies after these first experiments demonstrated that most of the impurities deposited in the divertor originate in the main chamber, and that asymmetric deposition patterns generally favouri…

Preprint Published
2018

The first divertor was installed in the JET machine between 1992 and 1994 and was operated with carbon tiles and then beryllium tiles in 1994–5. Post-mortem studies after these first experiments demonstrated that most of the impurities deposited in the divertor originate in the main chamber, and that asymmetric deposition patterns generally favou…

Published
2015
CCFE-PR(15)25

A set of Be and W tiles removed after the first ITER-like Wall campaigns (JET-ILW) from 2011-2012 has been analysed. The results indicate that the primary erosion site is in the main chamber (Be) as in previous carbon campaigns (JET-C). In particular the limiters tiles near the mid-plane are eroded probably during the limiter phases of discharges. …

Preprint Published
2015
CCFE-PR(15)21

Selected Ion Beam Analysis techniques applicable for detecting deuterium and heavier impurities have been used in the post-mortem analyses of tiles removed after the first JET ITER-Like Wall (JET-ILW) campaign. Over half of the retained fuel was measured in the divertor region. The highest figures for fuel retention were obtained from regions with …

Preprint Published
2014

This paper reports on the first post-mortem analyses of tiles removed from JET after the first campaigns with the ITER-like Wall (ILW) during 2011-2 [1]. Tiles from the divertor have been analysed by the Ion Beam Analysis (IBA) techniques Rutherford Backscattering Spectroscopy (RBS) and Nuclear Reaction Analysis (NRA) and by Secondary Ion Mass Spec…

Published
2013

A complete global balance for carbon in JET requires knowledge of the net erosion in the main chamber, net deposition in the divertor and the amount of dust and flakes collecting in the divertor region. This paper describes a number of measurements on aspects of this global picture. Profiler measurements and cross section microscopy on tiles that w…

Published
2008

Management of tritium inventory remains one of the grand challenges in the development of fusion energy, and the choice of plasma-facing materials is a key factor for in-vessel tritium retention. The Atomic and Molecular Data Unit of the International Atomic Energy Agency organized a Coordinated Research Project (CRP) on the overall topic of tritiu…

Published