-
CCFE-PR(16)182016
A subset of JET ITER-like wall (ILW) discharges, combining electron density and temperature as well as divertor heat flux measurements, has been collected for the validation of non-linear MHD simulations of Edge-Localised-Modes (ELMs). This permits a quantitative comparison of simulation results against experiments, which is required for the valida…
-
CCFE-PR(15)1152015
We present the application of an improved EDGE2D-EIRENE SOL transport model for the ELM phase utilizing kinetic correction of the sheath-heat-transmission coefficients and heat-flux-limiting factors used in fluid SOL modelling. With a statistical analysis over a range of similar Type-I ELMy H-mode discharges performed at the end of the first JET IT…
-
2014
Arcs are the potentially most dangerous events related to Lower Hybrid (LH) antenna operation. If left uncontrolled they can produce damage and cause plasma disruption by impurity influx. To address this issue an arc real time control and protection imaging system for the Joint European Torus (JET) LH antenna has been implemented. The LH system is …
-
2014
In 2011/12, JET started operation with its new ITER-Like Wall (ILW) made of a tungsten (W) divertor and a beryllium (Be) main chamber wall. The impact of the new wall materials on the JET Ion Cyclotron Resonance Frequency (ICRF) operation is assessed and some important properties of JET plasmas heated with ICRF are highlighted. A 20% reduction of t…
-
2014
The ITER-like wall (ILW) at JET is a unique opportunity to study the combination of material (beryllium and tungsten) that will be used for the plasma facing components (PFC) in ITER. Both the limiters (Be) and divertor (CFC W coated and bulk W) have been designed to maximise their power handling capability. During the last experimental campaign (O…
-
2013
When using Ion Cyclotron Range of Frequency (ICRF) heating, enhanced heat-fluxes are commonly observed on some plasma facing components close to the antennas. Experiments have recently been carried out on JET with the new ITER-Like-Wall (ILW) to characterize the heat flux to the JET ICRF antennas. Using Infra-Red thermography and thermal models of …
-
2012
The installation of international thermonuclear experimental reactor-relevant materials for the plasma facing components (PFCs) in the Joint European Torus (JET) is expected to have a strong impact on the operation and protection of the experiment. In particular, the use of all-beryllium tiles, which deteriorate at a substantially lower temperature…
-
2012
For the new ITER-like wall at JET, two new infrared diagnostics (KL9B, KL3B) have been installed. These diagnostics can operate between 3.5 and 5 µ m and up to sampling frequencies of ~ 20 kHz. KL9B and KL3B image the horizontal and vertical tiles of the divertor. The divertor tiles are tungsten coated carbon fiber composite except the central til…
Showing 1 - 8 of 8 UKAEA Paper Results
Page 1 of 1