-
2015
Nanoindentation has been performed on tungsten, unimplanted and helium-implanted to $ 600 appm, at temperatures up to 750 1 C. The hardening effect of the damage was 0.90 GPa at 50 1 C, but is negligible above 450 1 C. The hardness value at a given temperature did not change on re-testing after heating to 750 1 C. This suggests that the helium is t…
-
CCFE-PR(15)142015
The effects of ion irradiation in materials for research are usually limited to a shallow surface layer of the order of one micrometre in depth. Determining the mechanical properties of such irradiated materials requires techniques with high spatial resolution. Nanoindentation is a relatively simple method for investigating these shallow layers wit…
-
2014
The erosion and high neutron flux in a fusion power plant results in the need for frequent remote replacement of the plasma facing components. This is a complex and time consuming remote handling operation and its duration directly affects the availability and therefore the commercial viability of the power plant. A tool is needed to allow the main…
-
2014
The need to populate the fusion materials engineering data base has long been recognized, the IFMIF facility being the present proposed neutron source for this purpose. Re-evaluation of the regulatory approach for the EU proposed DEMO device shows that the specification of the neutron source can be reduced with respect to IFMIF, allowing lower risk…
-
2014
The materials engineering data base relevant to fusion irradiation is poorly populated and it has long been recognized that a fusion spectrum neutron source will be required, the facility IFMIF being the present proposal. Reevaluation of the regulatory approach for the EU proposed DEMO device shows that the purpose of the source can be changed from…
-
2013
Pure Fe and model Fe-Cr alloys containing 5, 10 and 14%Cr were irradiated with Fe+ ions at a maximum energy of 2MeV to the same dose of 0.6dpa at temperatures of 300°C, 400°C and 500°C, and at dose rates corresponding to 6 x 10-4 dpa/s and 3 x 10-5 dpa/s. All materials exhibited an increase in hardness after irradiation at 300°C. After irradiat…
-
2013
The materials engineering data base relevant to fusion irradiation is poorly populated and it has long been recognized that a fusion spectrum neutron source will be required, the facility IFMIF being the present proposal. Re-evaluation of the regulatory approach for the EU proposed DEMO device shows that the purpose of the source can be changed fro…
Showing 21 - 27 of 27 UKAEA Paper Results