-
2015
Nuclear data form the basis of the radiation transport codes used to design and simulate the behaviour of nuclear facilities, such as the ITER and DEMO fusion reactors. Typically these data and codes are biased towards fission and high-energy physics applications yet are still applied to fusion problems. With increasing interest in fusion applicati…
-
2015
This paper describes the methodology that has been developed and applied to derive the principal geom-etry of the main DEMO tokamak systems, in particular the radial and vertical cross section based on the systems code output parameters, while exact parameters are described elsewhere [1]. This procedure reviews the analysis of the radial and vertic…
-
2015
Nanoindentation has been performed on tungsten, unimplanted and helium-implanted to $ 600 appm, at temperatures up to 750 1 C. The hardening effect of the damage was 0.90 GPa at 50 1 C, but is negligible above 450 1 C. The hardness value at a given temperature did not change on re-testing after heating to 750 1 C. This suggests that the helium is t…
-
2013
This work presents new integral data measured at the ASP 14 MeV neutron irradiation facility at Aldermaston in the UK, which has recently become available for fusion-related work through the CCFE materials programme. Measurements of reaction products from activation experiments using elemental foils were carried out using gamma spectrometry in a hi…
-
2013
The calculation of activation inventories is a key input to virtually all aspects of the operation, safety and environmental assessment of nuclear plants. For the licensing of such devices, regulatory authorities will require proof that the calculations of structural material, fuel inventories, and calculations to which those quantities are the inp…
-
2013
The main populating and depopulating mechanisms of the excited energy levels of ions in plasmas with densities
-
2013
A complete global balance for carbon in JET requires knowledge of the net erosion in the main chamber, net deposition in the divertor and the amount of dust and flakes collecting in the divertor region. This paper describes a number of measurements on aspects of this global picture. Profiler measurements and cross section microscopy on tiles that w…
-
2013
Type-I Edge Localised Modes (ELMs) have been mitigated in MAST through the application of n = 3, 4, and 6 resonant magnetic perturbations. For each toroidal mode number of the non-axisymmetric applied fields, the frequency of the ELMs has been increased significantly, and the peak heat flux on the divertor plates reduced commensurately. This increa…
-
2012
The electron density and temperature profiles measured by the Thomson scattering diagnostic on the COMPASS tokamak are used for estimation of electron kinetic energy, energy confinement time, and effective charge number Z eff . Data are compared with the line-integrated electron density measured by a microwave interferometer in an ohmically heated …
-
2012
Two methods for calculating tearing mode stability are described in this paper. A fast method using the recently improved T7 code (Ham et al. 2012 Plasma Phys. Control. Fusion 54 025009) and a new method based on the MARS-F MHD stability code (Liu et al. 2000 Phys. Plasmas 7 3681) which constructs the tearing mode solution from calculated basis fun…
Showing 31 - 40 of 70 UKAEA Paper Results