-
CCFE-PR(16)802016
The Joint European Torus (JET) high resolution Thomson scattering (HRTS) system measures radial electron temperature and density profiles. One of the key capabilities of this diagnostic is measuring the steep pressure gradient, termed the pedestal, at the edge of JET plasmas. The pedestal is susceptible to limiting instabilities, such as Edge Local…
-
CCFE-PR(15)792015
The propagation of filaments in the Scrape Off Layer (SOL) of tokamaks largely determines the plasma profiles in the region. In a conduction limited SOL, parallel temperature gradients are expected, such that the resistance to parallel currents is greater at the target than further upstream. Since the perpendicular motion of an isolated filament is…
-
2016
Demountable superconducting magnet coils would offer signi fi cant benefits to commercial nuclear fusion power plants. Whether large pressed joints or large soldered joints provide the solution for demountable fusion magnets, a critical component or building block for both will be the many, smaller-scale joints that enable the supercurrent to leave…
-
CCFE-PR(16)752016
Recently, a scaling law describing the formation of defect clusters under irradiation has been established [1, 2]. A critical constraint associated with its application to phenomena occurring over a broad range of irradiation conditions is the limitation on the energy of incident particles. Incident neutrons or ions, with energies exceeding a certa…
-
CCFE-PR(16)312016
This paper describes a recent advances in merging/reconnection experiments in MAST, namely tomographic ion Doppler spectroscopy capability from 2013 which solves the problem of the absence of ion temperature profile measurement during the solenoid-less startup. Providing 32 channel line-integrated spectra from 0.25m< rtangential <1.1m are con…
-
CCFE-PR(16)372016
One of the primary requirements for breeder blankets in commercial DT fusion reactors is to produce sufficient tritium to sustain the plasma. Mixed bed solid-type breeder blankets are one possible design being investigated for use in power producing reactors. Current mixed bed designs tend to utilise a uniform mixture of neutron multiplier Be12Ti a…
-
CCFE-PR(16)152016
Accurately quantifying the transmutation rate of tungsten (W) under neutron irradiation is a necessary requirement in the assessment of its performance as an armour material in a fusion power plant. The usual approach of calculating average responses, assuming large, homogenised material volumes, is insu?cient to capture the full complexity of the …
-
CCFE-PR(16)352016
Carcinogenic risks of internal exposures to alpha-emitters (except radon) are relatively poorly understood. Since exposure may occur in environmental, malicious, accidental and occupational settings, understanding consequent risks is a priority for radiation protection. An occupational study in nuclear workers addresses this need as detailed histor…
-
CCFE-PR(16)512016
The properties of point defects in Fe-Cr-Ni alloys are investigated, using density functional theory (DFT), for two alloy compositions, Fe50Cr25Ni25 and Fe55Cr15Ni30, assuming various degrees of short-range order. DFT-based Monte Carlo simulations are applied to explore short-range order parameters and generate representative structures of alloys. …
-
CCFE-PR(16)572016
Ball-pen probes have been deployed in the SOL of numerous magnetic confinement experiments to make direct measurements of the plasma potential. They have also been used simultaneously with Langmuir probes to make fast measurements of the electron temperature. Despite strong empirical evidence for the success of the BPP it lacks a theoretical underp…
Showing 1411 - 1420 of 2526 UKAEA Paper Results