-
UKAEA-CCFE-PR(19)622019
The pedestal structure, ELM losses and linear MHD stability are analysed in a series of JET-ILW H and D type I ELMy H-mode plasmas. The pedestal pressure (pPED) is typically higher in D than in H at the same input power, with the difference mainly due to lower density in H than in D. At the same input power, the pedestal electron pres…
-
UKAEA-CCFE-PR(19)232018
We have modelled self-consistently the most efficient ways to fuel ITER Hydrogen (H), Helium (He) and Deuterium-Tritium (DT) plasmas with gas and/or pellet injection with the integrated core and 2D SOL/divertor suite of codes JINTRAC. As far as we are aware, for ITER this is the first time modelling of the entire plasma has been carried out to f…
-
UKAEA-CCFE-PR(18)222018
The operation of a tokamak designed to test the sustainability of a thermonuclear grade plasma like the International Tokamak Experimental Reactor (ITER) presents several challenges. Among them is the necessity of fuelling the plasma to reach the density required to generate enough fusion power to achieve Q = 10 and, at the same time, to protect th…
-
2016
There is experimental evidence that the pedestal dynamics in type-I ELMy H-mode discharges is significantly affected by a change in the recycling conditions at the tungsten plasma-facing components (W-PFCs) after an ELM event. The integrated code JINTRAC has been employed to assess the impact of recycling conditions during type-I ELMs in JET ITER-l…
-
CCFE-PR(15)292015
ITER operations require effective fuelling of the core plasma for conditions in which neutral dynamics through the scrape-off layer (SOL) is expected to affect significantly the efficiency of gas penetration. On the basis of previous analysis for stationary conditions, pellets are foreseen to provide core fuelling of high-Q DT scenarios. In this pa…
-
CCFE-PR(15)1112015
Recent studies dedicated to the characterisation of in-vessel dust in JET with the new ITER-like wall (ILW) show that dust levels are orders of magnitude lower compared with the latter stages of the carbon-wall (CW) period and are decreasing with operational time. Less than 1 g of dust was recovered in a recent inspection, compared with more than 2…
-
CCFE-PR(15)262015
A discrepancy in the divertor radiated powers between EDGE2D-EIRENE simulations, both with and without drifts, and JET-ILW experiments employing a set of NBI-heated L-mode discharges with step-wise density variation is investigated. Results from a VUV/visible poloidally scanning spectrometer are used together with bolometric measurements to determi…
-
CCFE-PR(15)1282015
The influence of the ITER-like Wall (ILW) with divertor target plate made of tungsten (W), on plasma performance in JET H-mode is being investigated since 2011 (see [1] and references therein). One of the key issues in discharges with low level of D fuelling is observed accumulation of W in the plasma core, which leads to a reduction in plasma perf…
-
CCFE-PR(15)1152015
We present the application of an improved EDGE2D-EIRENE SOL transport model for the ELM phase utilizing kinetic correction of the sheath-heat-transmission coefficients and heat-flux-limiting factors used in fluid SOL modelling. With a statistical analysis over a range of similar Type-I ELMy H-mode discharges performed at the end of the first JET IT…
Showing 11 - 19 of 19 UKAEA Paper Results