-
CCFE-PR(15)212015
Selected Ion Beam Analysis techniques applicable for detecting deuterium and heavier impurities have been used in the post-mortem analyses of tiles removed after the first JET ITER-Like Wall (JET-ILW) campaign. Over half of the retained fuel was measured in the divertor region. The highest figures for fuel retention were obtained from regions with …
-
CCFE-PR(15)192015
Rotating collectors are used in JET to provide time-resolved measurements of erosion and redeposition of vessel materials. The silicon collecting disks rotate behind an aperture, driven by pulsing of the toroidal magnetic field, with the deposits analysed ex-situ by Nuclear Reaction Analysis. The angular dependence of deposition is mapped to discha…
-
CCFE-PR(15)1282015
The influence of the ITER-like Wall (ILW) with divertor target plate made of tungsten (W), on plasma performance in JET H-mode is being investigated since 2011 (see [1] and references therein). One of the key issues in discharges with low level of D fuelling is observed accumulation of W in the plasma core, which leads to a reduction in plasma perf…
-
CCFE-PR(15)1152015
We present the application of an improved EDGE2D-EIRENE SOL transport model for the ELM phase utilizing kinetic correction of the sheath-heat-transmission coefficients and heat-flux-limiting factors used in fluid SOL modelling. With a statistical analysis over a range of similar Type-I ELMy H-mode discharges performed at the end of the first JET IT…
-
2015
A global signature of the build-up to an intrinsic edge localized mode (ELM) is found in the temporal analytic phase of signals measured in full flux azimuthal loops in the divertor region of JET. Toroidally integrating, full flux loop signals provide a global measurement proportional to the voltage induced by changes in poloidal magnetic flux; the…
-
2015
A unique sequence of 120 almost identical plasmas in the Joint European Torus (JET) recently provided two orders of magnitude more statistically equivalent data than ever previously available. The purpose was to study movement of eroded plasma-facing material from JET’s new Beryllium wall, but it has allowed the statistical detection of otherwise…
-
CCFE-PR(15)1232015
Heating single ion species plasmas with ICRF is a challenging task: Fundamental ion cyclotron heating (w = w ci ) suffers from the adverse polarization of the RF electric fields near the majority cyclotron resonance while second harmonic heating (w = 2w ci ) typically requires pre-heating of the plasma ions to become efficient. Recently, w = 2w ci …
-
CCFE-PR(15)1192015
In this paper, we present the work in the implementation of a new calibration for the JET real-time polarimeter based on the complex amplitude ratio technique and a new self-validation mechanism of data. This allowed easy integration of the polarimetry measurements into the JET plasma density control (gas feedback control) and as well as machine pr…
-
CCFE-PR(15)1182015
The H-mode pedestal plays an important role in determining global confinement in tokamaks. In high triangularity H-mode experiments in Joint European Torus with the ITER-like wall (JET-ILW), significantly higher pedestal temperature and global confinement have been achieved with nitrogen seeding. The experimentally observed increase in pedestal hei…
-
CCFE-PR(15)1102015
In this report key aspects of Lower Hybrid Current Drive (LHCD) operation at JET are presented. Amplitude and broadening of the Radio Frequency (RF) spectrum at about 3.7GHz and the frequency shift of the lower sideband were analyzed by means of new diagnostic utilizing RF spectra measurements. Dependencies on plasma density, LH power and the toroi…
Showing 321 - 330 of 510 UKAEA Paper Results