-
UKAEA-CCFE-CP(24)092023
The JET ITER-like Wall (ILW) divertor mostly consists of CFC tiles coated with a thick tungsten (W) layer over a molybdenum (Mo) interlayer. Poloidal sets of tiles are additionally coated with ~3 microns of Mo and ~4 microns of W to act as markers to measure the erosion/deposition during ILW campaigns. A few of the marker tiles only have the Mo …
-
UKAEA-CCFE-CP(21)122021
This contribution outlines a strategy for assessing tritium (T) inventory in plasma facing components (PFC) during JET T operations. It is based on retention as a fraction of fuel injected in-vessel, currently reported as 0.24% for 2011-2012 operating period, in conjunction with the planned T pulse schedule providing fueling of 4 g T injected per d…
-
UKAEA-CCFE-PR(21)262021
The first divertor was installed in the JET machine between 1992 and 1994 and was operated with carbon tiles and then beryllium tiles in 1994-5. Post-mortem studies after these first experiments demonstrated that most of the impurities deposited in the divertor originate in the main chamber, and that asymmetric deposition patterns generally favouri…
-
UKAEA-CCFE-CP(20)742020
Post mortem analysis shows that mid and high atomic number metallic impurities are present in deposits on JET plasma facing components with the highest amount of Ni and W, and therefore the largest sink, being found at the top of the inner divertor. Sources are defined as “continuous” or “specific”, in that “continuous” sources…
-
2018
The first divertor was installed in the JET machine between 1992 and 1994 and was operated with carbon tiles and then beryllium tiles in 1994–5. Post-mortem studies after these first experiments demonstrated that most of the impurities deposited in the divertor originate in the main chamber, and that asymmetric deposition patterns generally favou…
-
CCFE-PR(15)252015
A set of Be and W tiles removed after the first ITER-like Wall campaigns (JET-ILW) from 2011-2012 has been analysed. The results indicate that the primary erosion site is in the main chamber (Be) as in previous carbon campaigns (JET-C). In particular the limiters tiles near the mid-plane are eroded probably during the limiter phases of discharges. …
-
CCFE-PR(15)212015
Selected Ion Beam Analysis techniques applicable for detecting deuterium and heavier impurities have been used in the post-mortem analyses of tiles removed after the first JET ITER-Like Wall (JET-ILW) campaign. Over half of the retained fuel was measured in the divertor region. The highest figures for fuel retention were obtained from regions with …
-
2014
This paper reports on the first post-mortem analyses of tiles removed from JET after the first campaigns with the ITER-like Wall (ILW) during 2011-2 [1]. Tiles from the divertor have been analysed by the Ion Beam Analysis (IBA) techniques Rutherford Backscattering Spectroscopy (RBS) and Nuclear Reaction Analysis (NRA) and by Secondary Ion Mass Spec…
-
2013
A complete global balance for carbon in JET requires knowledge of the net erosion in the main chamber, net deposition in the divertor and the amount of dust and flakes collecting in the divertor region. This paper describes a number of measurements on aspects of this global picture. Profiler measurements and cross section microscopy on tiles that w…
-
2008
Management of tritium inventory remains one of the grand challenges in the development of fusion energy, and the choice of plasma-facing materials is a key factor for in-vessel tritium retention. The Atomic and Molecular Data Unit of the International Atomic Energy Agency organized a Coordinated Research Project (CRP) on the overall topic of tritiu…
Showing 1 - 10 of 10 UKAEA Paper Results
Page 1 of 1