-
CLM P21961
-
UKAEA-CCFE-PR(20)042020
The development of a commercial fusion power plant presents a unique set of challenges associated with the complexity of the systems, the integration of novel technologies, the likely diversity and distribution of the organisations involved and the scale of resources required. A framework for creating a digital environment that integrates researc…
-
UKAEA-CCFE-PR(19)622019
The pedestal structure, ELM losses and linear MHD stability are analysed in a series of JET-ILW H and D type I ELMy H-mode plasmas. The pedestal pressure (pPED) is typically higher in D than in H at the same input power, with the difference mainly due to lower density in H than in D. At the same input power, the pedestal electron pres…
-
UKAEA-CCFE-PR(19)512019
Only limited data exist on the effect of neutron irradiation on the brittle to ductile transition (BDT) in tungsten. This work investigates the increase in brittle to ductile transition temperature (BDTT) following neutron irradiation to 1.67 displacements per atom, using four-point bend tests over a range of temperatures (623 – 1173 K) and strai…
-
UKAEA-CCFE-CP(19)042018
Waste-production predictions for the future demonstration fusion power plant (DEMO) are necessary to produce an accurate picture of the likely environmental and economic costs of radioactive waste disposal at end-of-life (EOL). Even during the conceptual stage of DEMO design it is important to perform waste assessment so as to avoid potential surpr…
-
UKAEA-CCFE-PR(18)32018
Recent studies have shown that on JET with the Be/W ITER-like wall (JET-ILW) in high beta discharges with high D2 gas rates the inter-ELM temperature pedestal growth is saturated half way through the ELM cycle, leading to plasmas with reduced confinement, and that the linear MHD stability of these pedestals is inconsistent with the Peeling-Ballooni…
-
CCFE-PR(17)082017
Inventory calculations have a key role to play in designing future fusion power plants because, for a given irradiation field and material, they can predict the time evolution in chemical composition, activation, decay heat, gamma-dose, gas production, and even damage (dpa) dose. For conceptual designs of the European DEMO fusion reactor such calcu…
-
CCFE-PR(16)242016
Rotating collectors and quartz microbalances (QMBs) are used in JET to provide time-dependent measurements of erosion and deposition. Rotation of collector discs behind apertures allows recording of the long term evolution of deposition. QMBs measure mass change via the frequency deviations of vibrating quartz crystals. These diagnostics are used t…
-
CCFE-PR(16)102016
The magnetic perturbations produced by the resonant magnetic perturbation (RMP) coils will be rotated in ITER so that the spiral patterns due to strike point splitting which are locked to the RMP also rotate. This is to ensure even power deposition on the divertor plates. VMEC equilibria are calculated for different phases of the RMP rotation. It i…
-
CCFE-PR(16)802016
The Joint European Torus (JET) high resolution Thomson scattering (HRTS) system measures radial electron temperature and density profiles. One of the key capabilities of this diagnostic is measuring the steep pressure gradient, termed the pedestal, at the edge of JET plasmas. The pedestal is susceptible to limiting instabilities, such as Edge Local…
Showing 41 - 50 of 89 UKAEA Paper Results