-
UKAEA-CCFE-PR(18)812018
Fast ion synergistic effects were studied by predictive modelling of JET best performing pulses for various levels of Neutral Beam (NB) and Radio Frequency (RF) power. Calculated DD neutron yields were analysed with the intention of separating the impact of sheer synergistic effects due to changes in fast ion (FI) distribution function (DF) from su…
-
UKAEA-CCFE-PR(18)722018
Formation and migration energies, elastic dipole and relaxation volume tensors of nano-defects are the parameters that determine the rates of evolution of microstructure under irradiation and the magnitude of macroscopic elastic stresses and strains resulting from the accumulation of defects in materials. To find accurate values of these parameters…
-
UKAEA-CCFE-PR(18)662018
Functional materials’ properties are influenced by microstructures which can be changed during manufacturing. Experimental characterisation is often time consuming and expensive. A technique is presented which digitises graphite foam via X-ray tomography and converts it into image-based models to determine properties in silico. By simulating a la…
-
UKAEA-CCFE-PR(18)592018
A Neutron Camera (NC) was used on the Mega Ampere Spherical Tokamak (MAST) to measure the DD neutron emissivity along four collimated lines of sight, two on-axis and two off-axis, all viewing the plasma in tangential direction. The encouraging results obtained suggested that an upgraded NC for MAST-U would provide fundamental information for the st…
-
UKAEA-CCFE-PR(18)602018
The European DEMO fusion power reactor (EU-DEMO) is still in the pre-conceptual design phase. The design strategy for the EU-DEMO hinges on investigating multiple reactor designs and technologies in parallel, progressively down-selecting these in the mid-2020’s, in preparation for the conceptual design phase. The present implementation of the str…
-
UKAEA-CCFE-PR(18)532018
Within a tokamak fusion energy device, the performance and lifespan of a divertor monoblock under high heat flux cycles is of particular interest. Key to this is the quality of manufacture, especially the material joining interfaces. Presented here is a comparative study between X-ray and neutron tomography to investigate the quality of manufacture…
-
UKAEA-CCFE-PR(18)492018
Predicting strains, stresses and swelling in power plant components exposed to irradiation directly from the observed or computed defect and dislocation microstructure is a fundamental problem of fusion power plant design that has so far eluded a practical solution. We develop a model, free from parameters not accessible to direct evaluation or obs…
-
UKAEA-CCFE-PR(18)472018
The Gyrokinetic Toroidal Code (GTC) has been used to study Toroidal Alfvén Eigenmodes (TAEs) in high-performance plasmas. Experiments performed at the Joint European Torus, where TAEs were driven by energetic particles arising from Neutral Beams, ion cyclotron resonant heating and resonantly excited by dedicated external antennas, have been simula…
-
UKAEA-CCFE-PR(18)442018
High-Z impurities in magnetic confinement devices are prone to develop density variations on the fluux-surface, which can significantly affect their transport. In this paper, we generalize earlier analytic stellarator calculations of the neoclassical radial impurity flux in the mixed-collisionality regime (collisional impurity and low-collisionalit…
-
UKAEA-CCFE-PR(18)322018
Progress in understanding lower hybrid current drive (LHCD) at high density has been made through experiments and modeling, which is encouraging given the need for an efficient off-axis current profile control technique in burning plasma. By reducing the wall recycling of neutrals, the edge temperature is increased and the effect of parametric inst…
Showing 261 - 270 of 438 UKAEA Paper Results