-
UKAEA-CCFE-CP(18)052018
Pellets are used in ASDEX Upgrade [1] to control plasma density under conditions of ELM control or divertor detachment. In experiments presented here direct fuelling by gas is negligible. Relative pellet size and pellet deposition are aimed to approach those in ITER but differences still remain. ELMs are controlled by n=2 RMPs in feed forward mode …
-
UKAEA-CCFE-CP(19)162018
Edge Localised Modes (ELMs) in H-mode tokamak plasmas may be controlled or entirely suppressed by applying 3D magnetic perturbations (MPs). The applied perturbation is amplified by the plasma response, and it has previously been established that the size of the peeling component of this response is a reliable indicator for expected ELM control on A…
-
UKAEA-CCFE-PR(18)692018
The impact of the three-dimensional (3D) tokamak geometry from external magnetic perturbations (MPs) on the local edge stability has been examined in high confinement mode (H-mode) plasmas with edge localised modes (ELMs) in ASDEX Upgrade. The 3D geometry has been probed using rigidly rotating MP fields. The measured distortions of the plasma bound…
-
UKAEA-CCFE-PR(18)452018
In magnetic fusion devices, unwanted non-axisymmetric magnetic eld perturbations, known as error fields (EF), can have detrimental effects on plasma stability and confinement. To minimize their impact on plasma performances and on the available operational space, it is important to identify the EF sources and develop EF control strategies. MAST Up…
-
CCFE-PR(17)702017
It has been previously demonstrated in (Li et al 2016 Nuclear Fusion 56 126007) that the optimum upper/lower coil phase shift ΔΦopt for alignment of RMP coils for ELM mitigation depends sensitively on q95, and other equilibrium plasma parameters. Therefore, ΔΦopt is expected to vary widely during the current ramp …
-
CCFE-PR(17)652017
Using high speed imaging of the divertor volume, the region close to the X-point in MAST is shown to be quiescent. This is confirmed by three different analysis techniques and the quiescent X-point region (QXR) spans from the separatrix to the N = 1.02 flux surface. Local reductions to the atomic density and effects associated with the camera vie…
-
CCFE-PR(17)582017
Methods for density control are of critical importance for future long pulse tokamaks. The EMC3-EIRENE code is being used to investigate the applicability of 3D non-axisymmetric fields for density control in standard and advanced divertor configurations in spherical tokamaks. Part of this effort is understanding Scrape Off layer (SOL) transport mec…
-
CCFE-PR(17)502017
The interaction of L-mode and inter-ELM Scrape-Off Layer (SOL) filaments is investigated by simulating the dynamics of two seeded density perturbations with different initial separation. A numerical campaign of 2D and 3D simulations is presented to explore the effect that different filaments' perpendicular size and relative distance have on their r…
-
CCFE-PR(17)112017
This work presents the first evidence of helical flow in RFX-mod q(a) < 2 tokamak plasmas. The flow pattern is characterized by the presence of convective cells with m = 1 and n = 1 periodicity in the poloidal and toroidal direction, respectively. A similar helical flow deformation has been observed in the same device when operatedfas a Reversed…
-
CCFE-PR(17)602017
Reciprocating Mach probe data is used to estimate the radial wave number of oscillatory zonal flows in Ohmic MAST plasma. An intermittent 10kHz mode is detected in the wavelet decomposition and windowed spectra of plasma potential fluctuations of the MAST tokamak edge plasma. Previously, this mode has been identified as a Geodesic Acoustic Mode (GA…
Showing 41 - 50 of 131 UKAEA Paper Results