-
UKAEA-CCFE-PR(22)502022
Fusion power plant designs based on magnetic confinement, such as the tokamak design, offer a promising route to sustainable fusion power but require robust exhaust solutions capable of tolerating intense heat and particle fluxes from the plasma to material surfaces. Turbulent plasma transport in the divertor volume – the region where the plasma-…
-
UKAEA-CCFE-PR(22)382022
Reduced activation ferritic martensitic (RAFM) and oxide dispersion strengthened (ODS) steels are the most promising candidates for fusion first-wall/blanket (FW/B) structures. The performance of these steels will deteriorate during service due to neutron damage and transmutation-induced gases, such as helium/hydrogen, at elevated operating tempera…
-
UKAEA-CCFE-PR(22)372022
Neutron flux measurements are important in fusion devices for both safety requirements and physics studies. A newsystem has been built for the Mega Amp Spherical Tokamak Upgrade (MAST Upgrade) that provides neutron count,DC and Campbell mode measurements for a 1μsperiod at 1 MHz. The acquisition system uses a Red Pitaya board tosample current from…
-
UKAEA-CCFE-PR(22)392022
In the absence of official standards and guidelines for nuclear fusion plants, fusion designers adopted, as far as possible, well-established standards for fission-based nuclear power plants (NPPs). This often implies interpretation and/or extrapolation, due to differences in structures, systems and components, materials, safety mitigation systems,…
-
UKAEA-CCFE-PR(22)482022
The evolution of SOL density profiles and fluctuations have been studied at different recycling levels in 3 different tokamaks, ASDEXUpgrade, TCV and JET, all operated in HMode. In all devices we clearly observe an increase of far SOL efolding length at high …
-
UKAEA-RACE-PR(22)052022
During the EU DEMO Pre-Concept Design Phase, the remote maintenance team developed maintenance strategies and systems to meet the evolving plant maintenance requirements. These were constrained by the proposed tokamak architecture and the challenging environments but considered a range of port layouts and handling system designs. The design‑d…
-
UKAEA-CCFE-PR(22)362022
There exists a large body of previous work using reduced two-dimensional models of the SOL, which model fluctuations in the drift-plane but approximate parallel transport with effective loss terms. Full size three-dimensional simulations of SOL turbulence in experimental geometries are now possible, but are far more computationally expensive than …
-
UKAEA-CCFE-PR(22)352022
Understanding generation and mitigation of runaway electrons in disruptions is important for the safe operation of future tokamaks. In this paper we investigate runaway dynamics in reactor-scale spherical tokamaks. We study both the severity of runaway generation during unmitigated disruptions, as well as the effect that typical mitigation schem…
-
UKAEA-CCFE-PR(22)342022
The feasibility of a new approach for pipe inspection has been explored using digital twins to enhance guided wave inspection. Guided wave inspection is well-established in the oil and gas industry to screen remotely long lengths of predominately straight pipeline for corrosion. However, inspection of complex geometries of pipe remains a challen…
-
UKAEA-STEP-CP(22)012022
With the ITER project entering the second half of the construction phase and various national and international plans for fusion prototype power plants being in early to advanced stages, fusion has entered the delivery era. With the urgency of the climate crisis being at the forefront of government policy agendas it is important to focus on the com…
Showing 671 - 680 of 2581 UKAEA Paper Results