-
CCFE-PR(17)412016
Four numerical codes are employed to investigate the dynamics of Scrape-Off Layer filaments in tokamak relevant conditions. Experimental measurements were taken in the MAST device using visual camera imaging, which allows the evaluation of the perpendicular size and velocity of the filaments, as well as the combination of density and temperature as…
-
CCFE-PR(16)272016
Retarding field energy analysers (RFEAs) have been used to compare the ion temperature ( T i ) of large plasma filaments with the background plasma (composed of small scale filaments) at the midplane and divertor target in L mode discharges in the Mega Amp Spherical Tokamak (MAST). At low densities, at the midplane and divertor, at distances from 2…
-
CCFE-PR(16)202016
A complete model of the dynamics of scrape-off layer filaments will be rather complex, including temperature evolution, three dimensional geometry and finite Larmor radius effects. However, the basic mechanism of E x B advection due to electrostatic potential driven by the diamagnetic current can be captured in a much simpler model; a complete unde…
-
CCFE-PR(16)172016
Measurements of local density and magnetic field fluctuations near the pedestal top, conditionally-averaged over the ELM cycle, have been made in MAST. A Doppler backscattering (DBS) system installed at MAST was used to measure intermediate-k (k ? _i _ 3 - 4) density fluctuations at the top of the pedestal. A novel diagnostic technique combining DB…
-
CCFE-PR(16)102016
The magnetic perturbations produced by the resonant magnetic perturbation (RMP) coils will be rotated in ITER so that the spiral patterns due to strike point splitting which are locked to the RMP also rotate. This is to ensure even power deposition on the divertor plates. VMEC equilibria are calculated for different phases of the RMP rotation. It i…
-
CCFE-PR(16)072016
The plasma response to the vacuum resonant magnetic perturbation (RMP) fields, produced by the ELM control coils in ASDEX Upgrade experiments, is computationally modelled using the MARS-F/K codes [Liu Y.Q. et al 2000 Phys. Plasmas 7 3681; Liu Y.Q. et al 2008 Phys. Plasmas 15 112503]. A systematic investigation is carried out, considering various pl…
-
CCFE-PR(16)062016
Experiments have been performed under the coordination of the International Tokamak Physics Activity (ITPA) on several tokamaks, including ASDEX Upgrade (AUG), JET and DIII-D, to characterize the increased ICRF antenna loading achieved by optimizing the position of gas injection relative to the RF antennas. On DIII-D, AUG and JET (with the ITER-Lik…
-
CCFE-PR(16)082016
Computations in toroidal geometry are systematically performed for the plasma response to 3D magnetic perturbations, produced by ferritic inserts (FIs) and test blanket modules (TBMs), for four ITER plasma scenarios: the 15MA baseline, the 12.5MA hybrid, the 9MA steady state, and the 7.5MA half-field Helium plasma. Due to broad toroidal spectrum of…
-
CCFE-PR(16)822016
We focus on JET plasmas in which ELMs are triggered by pellets in the presence of ELMs which occur naturally. We perform direct time domain analysis of signals from fast radial field coils and toroidal full flux azimuthal loops. These toroidally integrating signals provide simultaneous high time resolution measurements of global plasma dynamics and…
-
CCFE-PR(16)302016
In future nuclear fusion reactors high heat load events, such as edge-localised modes (ELMs), can potentially damage divertor materials and release impurities into the main plasma, limiting plasma performance. The most difficult to handle are type I ELMs since they carry the largest fraction of energy from the plasma and therefore deposit the large…
Showing 201 - 210 of 507 UKAEA Paper Results