-
2006
The maximum temperature expected in ITER is in the region of 40 keV and the minimum average density of approximately 310 19 m -3 is also expected. The proven capability, convenience, and port occupancy of the LIDAR Thomson scattering approach, demonstrated on JET, makes it an excellent candidate for ITER. Nonetheless, there are formidable design ch…
-
2006
A new edge Thomson scattering diagnostic has been implemented at MAST to complement an existing high spatial resolution ruby laser system and the high time sampling core Nd:YAG system. The Nd:YAG system comprises of four independently controllable lasers. Scattered light from these lasers is viewed at large scattering angle 153° by a special optic…
-
2006
Reversed shear Alfvén eigenmodes RSAE that were observed in the Joint European Torus (JET) [P. H. Rebut and B. E. Keen, Fusion Technol. 11 , 13 (1987)] and DIII-D [J. L. Luxon, Nucl. Fusion 42 , 614 (2002)] are studied with the ideal magnetohydrodynamic code NOVA-K C. [Z. Cheng, Phys. Rep. 211 , 1 (1992)]. It was found that the frequency behavior …
-
2006
During a recent reversed toroidal field (B T) campaign at the Joint European Torus (JET), experiments were performed to investigate the effect on sawteeth of neutral beam injection (NBI)-driven toroidal plasma rotation counter to the direction of the toroidal plasma current and B T . A power scan at constant density has permitted analytical continu…
-
2005
Alfven eigenmodes (AEs) are studied to assess their stability in high density reactor relevant regimes. Stable AEs are excited with active magnetohydrodynamics antennas in the range of the expected AE frequency. Toroidal Alfven eigenmode (TAE) damping rates have been observed in diverted and limited Ohmic plasmas. Energetic particle modes or TAEs h…
-
2005
Self-consistent simulations of the International Thermonuclear Experimental Reactor (ITER) [R.Aymar, P. Barabaschi, and Y. Shimomura, Plasma Phys. Controlled Fusion 44, 519 (2002)] have been carried out using the JETTO-integrated modeling code in which theory-motivated models are used for the H-mode pedestal and for the stability conditions that le…
-
2004
Simulations of three Joint European Torus [P. H. Rebut et al., Nucl. Fusion 25, 1011 (1985)] type I ELMy high-confinement discharges in a power scan are carried out using the JETTO integrated modeling code [M. Erba et al., Plasma Phys. Controlled Fusion 39, 261 (1997)] with predictive core and pedestal models, which include the effect of edge local…
-
2003
Studies of type 1 ELMy H-mode pedestals are carried out using 0 D and 1.5 D approaches. In the 0 D study, predicted pedestal temperatures are compared with 533 data points. The pedestal temperature models, with pedestal width based on magnetic and flow shear stabilization and neutral penetration, yield an RMSE of 32% and 53.4%, respectively, when c…
-
2001
The equilibrium state in tokamak core plasmas has been studied using the relative intensities of resonance x-ray lines. A full spatial analysis involves comparison of the line intensities with ion diffusion calculations, including relevant atomic rates. A zero-dimensional model using a global ion loss rate approximation has also been demonstrated b…
-
2001
Simultaneous current ramping and application of lower hybrid heating and current drive (LHCD) have produced a region with zero current density within measurement errors in the core of JET tokamak optimized shear discharges. The reduction of core current density is consistent with a simple physical explanation and numerical simulations of radial cur…
Showing 251 - 260 of 266 UKAEA Paper Results