-
UKAEA-CCFE-PR(25)2722025
The development and distribution of microscopic shear strain have been investigated using high-resolution digital image correlation at the onset of plastic deformation in face-centred cubic CoCrFeNi high entropy al- loys with different grain sizes. Microscopic strain localisation increased with grain size as shown by the presence of planar slip …
-
UKAEA-CCFE-PR(25)2652025
The development of discrete strain at the microstructural scale during the onset of plasticity is potentially linked to fatigue crack nucleation in engineering alloys. Hence, quantifying such discrete strain and its evolution is a pathway to understand the microstructural influence on fatigue crack nucleation and to develop crack initiation mode…
-
UKAEA-CCFE-PR(24)2652024
Dedicated experiments were performed on MAST Upgrade to study beam-ion losses caused by charge exchange (CX) with edge neutrals. The fuelling was switched from the high-field side to the low-field side mid-discharge. Direct measurements suggest a strong increase in neutral density around the plasma and a deterioration of the beam-ion confinement…
-
UKAEA-STEP-PR(24)122024
Ensuring tritium fuel self-sufficiency while maintaining continuous and high specification fuel flow to the tokamak via a low tritium inventory and controllable fuel cycle is a significant challenge to the STEP plant design. Effective and high-quality fuelling and exhausting is required to sustain and control a stable plasma, whereas fuel suffic…
-
UKAEA-CCFE-PR(24)2152024
The first observations and classification of sub-cyclotron frequency range Alfvén eigenmodes (AEs) are presented for the MAST Upgrade tokamak. Sets of observed eigenmodes are separated by approximately 200 kHz. We observe a low frequency separation of ~10 kHz within the set, and the toroidal mode number n increases with frequency sequentially. …
-
UKAEA-CCFE-PR(25)2902023
The augmentation of mechanical properties of reduced activation ferritic martensitic steels through the introduction of creep resistant nano-oxide particles produces a class of oxide dispersion strengthened steels, which have attracted significant interest as candidates for first wall supporting structural materials in future nuclear fusion reac…
-
UKAEA-CCFE-PR(25)2842023
Nuclear fusion is a potential source of electricity which can address the environmental problems posed by fossil fuels. Eurofer97 steel is a primary structural material for breeding blanket and divertorcomponents in fusion Tokamaks.. Assembling and maintaining the structural integrity of these in-vessel components requires remote joint technique…
-
UKAEA-CCFE-PR(24)2402023
In this study, we compare the formation of radiation induced defects in W and W-Re-Os alloys, exposed to an equivalent dose of self-ion and neutron irradiation. Transmutation reactions in the neutron irradiated material are simulated in the ion implanted materials by alloying with representative quantities of Re and Os (1.4 and 0.1 at.% respecti…
-
UKAEA-CCFE-PR(23)1832023
The development of improved designs for components which will be subject to high heat fluxes has been identified as a critical challenge for the realisation of commercial fusion power. This paper presents details of a facility which allows early verification of thermofluid and thermomechananical performance of prototype components and enables compa…
-
UKAEA-CCFE-PR(23)1622023
A method for determining the fast-ion population density in magnetically-confined plasmas as a function of radius-pitch values, (R, Lambda), using ssNPA-signal and NBI power-output data has been developed. Oscillations in the NBI power output are replicated only in the active part of the ssNPA signal, allowing this to be separated…
Showing 1 - 10 of 58 UKAEA Paper Results