-
2013
One of the main approaches to thermonuclear fusion relies on confining high temperature plasmas with properly shaped magnetic fields. The determination of the magnetic topology is, therefore, essential for controlling the experiments and for achieving the required performance. In Tokamaks, the reconstruction of the fields is typically formulated as…
-
2013
This work isolated the cause of the observed discrepancy between the electron temperature (Te) measurements before and after the JET Core LIDAR Thomson Scattering (TS) diagnostic was upgraded. In the upgrade process, stray light filters positioned just before the detectors were removed from the system. Modelling showed that the shift imposed on the…
-
2013
The pedestal profile measurements in high triangularity JET plasmas show that with low fuelling the pedestal width decreases during the ELM cycle and with high fuelling it stays constant. In the low fuelling case the pedestal pressure gradient keeps increasing until the ELM crash and in the high fuelling case it initially increases then saturates d…
-
2013
The aim of the JET ITER-like Wall Project was to provide JET with the plasma facing material combination now selected for the DT phase of ITER (bulk beryllium main chamber limiters and a full tungsten divertor) and, in conjunction with the upgraded neutral beam heating system, to achieve ITER relevant conditions. The design of the bulk Be plasma fa…
-
2013
This paper will discuss simulations of the full ionization process (i.e. plasma burn-through), fundamental to creating high temperature plasma. By means of an applied electric field, the gas is partially ionized by the electron avalanche process. In order for the electron temperature to increase, the remaining neutrals need to be fully ionized in t…
-
2013
In this paper important aspects of Lower Hybrid (LH) operation with the ITER Like Wall (ILW) [1] at JET are reported. Impurity release during LH operation was investigated and it was found that there is no significant Be increase with LH power. Concentration of W was analysed in more detail and it was concluded that LH contributes negligibly to its…
-
2013
The main populating and depopulating mechanisms of the excited energy levels of ions in plasmas with densities
-
2013
A load-tolerant External Conjugate-T (ECT) impedance matching system for two A2 Ion Cyclotron Resonance Heating (ICRH) antennas has been successfully put into operation at JET. The system allows continuous injection of the RF power into plasma in the presence of strong antenna loading perturbations caused by Edge Localized Modes (ELMs). Reliable EC…
-
2013
This paper presents the DYON simulations of the plasma burn-through phase at Joint European Torus (JET) with the ITER-like wall. The main purpose of the study is to validate the simulations with the ITER-like wall, made of beryllium. Without impurities, the burn-through process of a pure deuterium plasma is described using DYON simulations, and the…
-
2013
A complete global balance for carbon in JET requires knowledge of the net erosion in the main chamber, net deposition in the divertor and the amount of dust and flakes collecting in the divertor region. This paper describes a number of measurements on aspects of this global picture. Profiler measurements and cross section microscopy on tiles that w…
Showing 191 - 200 of 223 UKAEA Paper Results