-
UKAEA-CCFE-PR(22)472022
The MAST Upgrade tokamak has a suite of foil bolometers to measure the total radiated power from the plasma. Arrays of bolometers provide coverage of the main chamber and lower divertor radiation. Data is digitised and processe…
-
UKAEA-CCFE-PR(22)442022
Tokamak edge (scrape-off layer) plasmas can exhibit non-local transport in the direction parallel to the magnetic field due to steep temperature gradients.This effect along with its consequences has been explored at equilibrium fora range of conditions, from sheath-limited to detached, using the 1D kinetic electron code SOL-KiT, where the electrons…
-
UKAEA-CCFE-CP(22)082022
The charged particle heat load assessed for the DEMO Single Module Segment First Wall (FW) during current off-normal plasma scenarios underlines that protection is needed for avoiding/reducing damage to the Breeding Blanket FW due to the deposition of a huge amount of energy in a small timescale. Within the “Key Design Integration Issue 1”, an…
-
UKAEA-CCFE-PR(22)402022
In this paper, we review the confinement and transport properties observed and predicted in low aspect ratio tokamaks, or spherical tokamaks (STs), which can depart significantly from those observed at higher aspect ratio. In particular, thermal energy confinement scalings show a strong, near linear dependence of energy confinement time on toroidal…
-
UKAEA-CCFE-PR(22)382022
Reduced activation ferritic martensitic (RAFM) and oxide dispersion strengthened (ODS) steels are the most promising candidates for fusion first-wall/blanket (FW/B) structures. The performance of these steels will deteriorate during service due to neutron damage and transmutation-induced gases, such as helium/hydrogen, at elevated operating tempera…
-
UKAEA-CCFE-PR(22)332022
Screening of high-Z (W) impurities from the confined plasma by the temperature gradient at the hot edge pedestal of fusion-grade H-mode plasmas has been demonstrated for the first time in the JET-ILW tokamak. Through careful optimisation of the hybrid-scenario, deuterium plasmas with sufficient heating power (≳ 32MW), high enough ion temperature …
-
UKAEA-CCFE-PR(22)262022
All high field superconductors producing magnetic fields above 12 T are brittle. Nevertheless, they will probably be the materials of choice in commercial tokamaks because the fusion power density in a tokamak scales as the fourth power of magnetic field. Here we propose using robust, ductile superconductors during the reactor commissioning phase i…
-
UKAEA-CCFE-PR(22)212022
This paper describes the development of electromagnetic plasma burn-through model. Full circuit equations describing the currents in solenoid, poloidal field coil, and toroidally conducting passive structure have been integrated into the differential equation system of the plasma energy and particle balances in DYON. This enables consistent calcula…
-
UKAEA-CCFE-PR(22)062022
Intermittent fluctuations in the boundary of magnetically confined plasmas are investigated by numerical turbulence simulations of a reduced fluid model describing the evolution of the plasma density and electric drift vorticity in the two-dimensional plane perpendicular to the magnetic field. Two different cases are considered, one describing resi…
-
UKAEA-STEP-PR(22)022022
We describe a workflow that is able to approximate basic machine parameters (including but not limited to plasma current IP, major radius R0, toroidal magnetic field B0, fusion power Pfusion) based on the choice of maximum field BTF,max on the in-boa…
Showing 31 - 40 of 500 UKAEA Paper Results