-
UKAEA-CCFE-PR(26)4212025
The competing requirements of fusion breeder blankets and the high dimensionality of their design space necessitate a systematic treatment to map the variations in performance against given objective metrics and to understand the operational envelope. In this endeavour, a digital engineering pipeline for design evaluation and optimisation has be…
-
UKAEA-CCFE-CP(26)362025
Predicting with high accuracy (low uncertainty) the performance of tritium breeding systems is a must for design engineering of future fusion devices. Current modelling relies on scant experimental data and is known to have uncertainties that if realised in a real system would p…
-
UKAEA-CCFE-PR(25)3382025
Tungsten-based BCC superalloys utilising coherent intermetallic strengthening offer a route to improved high temperature
-
UKAEA-CCFE-PR(25)3192025
Fe–Cr binary alloys serve as simplified model systems to study irradiation damage relevant to fusion structural materials. Here, Fe-3%Cr and Fe-5%Cr samples were irradiated with 4 MeV Fe ions with a dose rate of 4 × 10⁻⁵ dpa/s across a linear thermal gradient (120°C–480°C) in a single experiment, enabling direct comparison of temperatu…
-
UKAEA-CCFE-PR(25)3092025
Neutral Beam Injection (NBI) is a powerful and very commonly used tool on machines used in the development of magnetically confined fusion power. Not all the neutral beam power is deposited within the plasma. This shinethrough power must be dealt with in the plasma vessel and any components irradiated by it must be protected against excessive he…
-
UKAEA-CCFE-PR(25)3082025
-
UKAEA-CCFE-PR(25)3012025
Detailed results are presented from the first experimental study of self-regulation between plasma relative density fluctuations and perpendicular velocity over limit cycle oscillations (LCO) across the edge and near scrape-off layer (SOL) regions of the MAST-U spherical tokamak. The start of the dithering phase is preceded by the localisation of t…
-
UKAEA-CCFE-PR(25)3952024
Measurements of lattice strain at high spatial resolution are becoming accessible and routine, owing to advances in imaging techniques such as 4D Scanning Transmission Electron Microscopy. This has the potential to enhance materials characterisation, but the data are difficult to interpret. We present a procedure for extracting local concentrations…
-
UKAEA-CCFE-PR(25)3692024
Plasma detachment in tokamaks is useful for reducing heat flux to the target. It involves interactions of the plasma with impurities and neutral particles, leading to significant losses of plasma power, momentum, and particles. Accurate mapping of plasma emissivity in the divertor and X-point region is essential for assessing the rel…
-
UKAEA-STEP-PR(24)132024
The purpose of the digital workstream is the shorten the pathway to delivering a working fusion pilot plant. As with any development pathway there are rate limiting steps in a programme, a fairly major challenge that is common across fusion concepts is the limited possibility of physical testing with conditions close to that of a first wall environ…
Showing 1 - 10 of 44 UKAEA Paper Results