-
UKAEA-STEP-PR(24)212024
The design, delivery, and operation of a large-scale infrastructure project is challenging at best. For the Spherical Tokamak for Energy Production (STEP) Prototype Powerplant (SPP), the challenges increase exponentially. In addition to being a large-scale infrastructure project, it is a cutting edge, first of a kind (FOAK) technology demonstrat…
-
UKAEA-CCFE-PR(25)2872023
Fast-particle driven Alfvén Eigenmodes have been observed in low-collisionality discharges with off-axis neutral beam injection (NBI), electron cyclotron resonance heating (ECRH) and a reduced toroidal magnetic field. During NBI and ECRH, toroidicity induced Alfvén Eigenmodes (TAEs) appear in frequency bands close to 200 kHz and energetic-part…
-
UKAEA-CCFE-PR(23)132023
Following the first Deuterium-Tritium Experiment (DTE1) at UKAEA, modifications were investigated to the Joint European Torus’ (JET) gas introduction systems to increase the gas feed capabilities of the JET facility to better support future campaigns. The gas introduction systems comprise the gas introduction and gas distribution system (GI/GD)…
-
UKAEA-CCFE-CP(23)432022
MAST Upgrade (MAST-U) is a new low aspect ratio device (R/a = 0.85/0.65 ~ 1.3) based on the MAST tokamak that started plasma operations in October 2020. It has substantial new capabilities compared with the original MAST device, with 19 new poloidal field coils (14 of which are within the vacuum vessel) and new, closed, up-down symmetric diverto…
-
UKAEA-CCFE-PR(21)642021
The Safety and Environmental Work Package (WPSAE) has the scope to progress the safety studies for the future EU DEMO reactor, in the frame of the Eurofusion programme. A Generic Site Safety Report (GSSR) has been designed to include all the steps necessary to cover the safety issues of the nuclear fusion plant, from the definition of principles an…
-
UKAEA-CCFE-PR(18)262018
Pre-conceptual design studies for a European Demonstration Fusion Power Plant (DEMO) have been in progress since 2014. At this stage, while a range of design options are being considered, it is essential that assessments are carried out of the safety and environmental impact of these options. This is not only to ensure that the DEMO plant is op…
-
2018
Access conditions for full suppression of edge localised modes (ELMs) by magnetic perturbations (MP) in low density high confinement mode (H-mode) plasmas are studied in the ASDEX Upgrade tokamak. The main empirical requirements for full ELM suppression in our experiments are: 1. The poloidal spectrum of the MP must be aligned for best plasma respo…
-
UKAEA-CCFE-CP(19)402019
In magnetic confinement devices, boundary turbulence is responsible for transporting plasma and energy from the well-confined region towards the material surfaces where it can severely harm reactor relevant machines. It is therefore essential to develop a solid understanding of the mechanisms behind the transport in the edge of the plasma. Large fl…
-
UKAEA-CCFE-PR(19)552019
In ITER and DEMO, achieving detachment at lower densities would allow to reduce the amount of impurity seeded and to improve confinement by running at lower separatrix densities. Analytic models predict that a increase of total flux expansion would allow such a reduction in upstream density at detachment. However, both experiments and modelling …
-
CCFE-PR(16)162016
Divertor detachment in the TCV tokamak has been investigated through experiments and modelling. Density ramp experiments were carried out in ohmic heated L-mode pulses with the ion B drift directed away from the primary X-point, similar to previous studies [pitts2001]. Before the roll-over in the ion current to the outer strike point, C III and D? …
Showing 1 - 10 of 16 UKAEA Paper Results