-
CCFE-PR(16)782016
The dynamics and stability of divertor detachment in N2 seeded, type-I, ELMy H-mode plasmas with dominant NBI heating in the JET-ILW device is studied by means of an integrated analysis of diagnostic data from several systems, classifying data relative to the ELM times. It is thereby possible to study the response of the detachment evolution to the…
-
2016
Five ELMy H-mode Ne seeded JET pulses have been simulated with the self-consistent core-SOL model COREDIV. In this five pulse series only the Ne seeding rate was changed shot by shot, allowing a thorough study of the effect of Ne seeding on the total radiated power and of its distribution between core and SOL to be made. The increase in the simulat…
-
2016
There is experimental evidence that the pedestal dynamics in type-I ELMy H-mode discharges is significantly affected by a change in the recycling conditions at the tungsten plasma-facing components (W-PFCs) after an ELM event. The integrated code JINTRAC has been employed to assess the impact of recycling conditions during type-I ELMs in JET ITER-l…
-
CCFE-PR(16)242016
Rotating collectors and quartz microbalances (QMBs) are used in JET to provide time-dependent measurements of erosion and deposition. Rotation of collector discs behind apertures allows recording of the long term evolution of deposition. QMBs measure mass change via the frequency deviations of vibrating quartz crystals. These diagnostics are used t…
-
CCFE-PR(16)232016
JET components are removed periodically for surface analysis to assess material migration and fuel retention. This paper describes issues related to handling JET components and procedures for preparing samples for analysis; in particular a newly developed procedure for cutting beryllium tiles is presented. Consideration is also given to the hazards…
-
CCFE-PR(16)222016
An overview is given on the recent progress on edge modelling activities for the JET ITER like wall using the computational tools like the SOLPS or EDGE2D-EIRENE code. The validation process of these codes on JET with its metallic plasma-facing components is an important step towards predictive studies for ITER and DEMO in relevant divertor operati…
-
CCFE-PR(16)192016
ELM control may be essential to develop ITER scenarios with a reasonable lifetime of divertor components, whilst ELM pacing may be essential to develop stationary ITER scenarios with a tungsten divertor. Resonant magnetic perturbations (RMPs) have mitigated ELMs in high collisionality plasmas in JET. The efficacy of RMPs in mitigating the ELMs is f…
-
CCFE-PR(16)182016
A subset of JET ITER-like wall (ILW) discharges, combining electron density and temperature as well as divertor heat flux measurements, has been collected for the validation of non-linear MHD simulations of Edge-Localised-Modes (ELMs). This permits a quantitative comparison of simulation results against experiments, which is required for the valida…
-
CCFE-PR(16)842016
A new resistive bolometer system has been developed for MAST-Upgrade. It will measure radiated power in the new Super-X divertor, with millisecond time resolution, along 16 vertical and 16 horizontal lines of sight. The system uses a Xilinx Zynq-7000 series Field-Programmable Gate Array (FPGA) in the D-TACQ ACQ2106 carrier to perform real time data…
-
CCFE-PR(16)802016
The Joint European Torus (JET) high resolution Thomson scattering (HRTS) system measures radial electron temperature and density profiles. One of the key capabilities of this diagnostic is measuring the steep pressure gradient, termed the pedestal, at the edge of JET plasmas. The pedestal is susceptible to limiting instabilities, such as Edge Local…
Showing 131 - 140 of 223 UKAEA Paper Results