-
UKAEA-CCFE-PR(23)1192023
MAST Upgrade has just begun its second physics campaign. The set of magnetic probes used to diagnose the magnetic field and currents on MAST Upgrade are described, and their calibration procedures outlined including calculation of uncertainties. The arrays of installed instability diagnostics are described and the detection and diagnosis of a speci…
-
UKAEA-CCFE-CP(23)022023
Understanding the plasma parameters that affect the scrape off layer (SOL) width is a key issue for future tokamaks as the power entering the SOL (of order 100 MW [1] in ITER) and the SOL width (of order millimetres [2]) determine the heat flux to the divertor surfaces. The Eich scaling [2] can be used to characterise the divertor heat flux prof…
-
UKAEA-CCFE-CP(23)382022
The high ductile-to-brittle transition temperature (DBTT) of tungsten combined with its high hardness make machining incredibly difficult. These properties typically result in the poor-quality machined surfaces and short tool life. In this study, TiAlN coated carbide tools with different rake angles (8°, 10° and 12°) were tested in convention…
-
UKAEA-STEP-PR(23)032022
Commercial fusion power plants will require strong magnetic fields that can only be achieved using state-of-the-art high temperature superconductors in the form of REBCO coated conductors. In operation in a fusion machine, the magnet windings will be exposed to fast neutrons that are known to adversely affect the superconducting properties of RE…
-
UKAEA-CCFE-PR(22)872022
The neutral ionisation model proposed by R J Groebner et al. (Phys Plasmas 9 2134 (2002)) to determine the plasma density profile in the H-mode pedestal, extended to include charge exchange processes in the pedestal stimulated by the ideas of Mahdavi et al. ((Phys Plasmas 10 3984 (2003)). The model is then teste…
-
UKAEA-CCFE-PR(22)372022
Neutron flux measurements are important in fusion devices for both safety requirements and physics studies. A newsystem has been built for the Mega Amp Spherical Tokamak Upgrade (MAST Upgrade) that provides neutron count,DC and Campbell mode measurements for a 1μsperiod at 1 MHz. The acquisition system uses a Red Pitaya board tosample current from…
-
UKAEA-CCFE-PR(23)1042021
MAST pedestal data has been analysed, where a pedestal database of 892 shots was obtained, using the new upgraded MAST Thomson Scattering (TS) diagnostic. Various ELM types are discussed, where characteristics and trends of MAST pedestals are shown. The data from the upgraded TS diagnostic confirms pedestal characteristics found in earlier analy…
-
UKAEA-CCFE-CP(23)202021
Disruption prediction and avoidance is critical for ITER and reactor-scale tokamaks to maintain steady plasma operation and to avoid damage to device components. The present status and results from the disruption event characterization and forecasting (DECAF) research effort are shown. The DECAF paradigm is primarily physics-based and provides q…
-
UKAEA-CCFE-CP(23)142021
The high heat fluxes to the divertor during edge localised mode (ELM) instabilities have to be reduced for a sustainable future tokamak reactor. A solution to reduce the heat fluxes could be the Super-X divertor, this divertor configuration will be tested on MAST-U. ELM simulations for MAST-U Super-X tokamak plasmas have been obtained, using JOR…
-
UKAEA-CCFE-PR(21)822021
The benefits of an optimised Super-X divertor configuration in mitigating the steady-state power and particle fluxes to the surfaces of the MAST Upgrade divertor have been quantified by performing a detailed comparison with a conventional divertor for the first time. In otherwise identical plasmas with conventional and Super-X divertor configu…
Showing 11 - 20 of 128 UKAEA Paper Results