-
UKAEA-CCFE-CP(19)172019
-
UKAEA-CCFE-CP(19)132019
Empirically-based power-balance calculations of the inter-ELM separatrix loss power are presented for JET pulses with both the carbon- (JET-C) and ITER-like (JET-ILW) walls, to facilitate comparisons with results of on-going, non-linear gyro-kinetic calculations of pedestal heat transport, e.g. as reported in [1]. These might be able to explain the…
-
UKAEA-CCFE-PR(19)622019
The pedestal structure, ELM losses and linear MHD stability are analysed in a series of JET-ILW H and D type I ELMy H-mode plasmas. The pedestal pressure (pPED) is typically higher in D than in H at the same input power, with the difference mainly due to lower density in H than in D. At the same input power, the pedestal electron pres…
-
UKAEA-CCFE-PR(19)492019
EDGE2D-EIRENE (the ‘code’) simulations show that radial electric field, Er, in the near scrape-off layer (SOL) of tokamaks can have large variations leading to a strong local E´B shear greatly exceeding that in the core region. This was pointed out in simulations of JET plasmas with varying divertor geometry, where the magnetic conf…
-
UKAEA-CCFE-PR(18)32018
Recent studies have shown that on JET with the Be/W ITER-like wall (JET-ILW) in high beta discharges with high D2 gas rates the inter-ELM temperature pedestal growth is saturated half way through the ELM cycle, leading to plasmas with reduced confinement, and that the linear MHD stability of these pedestals is inconsistent with the Peeling-Ballooni…
-
CCFE-PR(17)132017
Future devices like JT-60SA, ITER and DEMO require quantitative predictions of pedestal density and temperature levels, as well as inter-ELM and ELM divertor heat fluxes, in order to improve global confinement capabilities while preventing divertor erosion/melting in the planning of future experiments. Such predictions can be obtained from dedicate…
-
CCFE-PR(15)442015
The effects of poloidal asymmetries and heated minority species are shown to be necessary to accurately describe heavy impurity transport in present experiments in JET and ASDEX Upgrade. Plasma rotation, or any small background electrostatic field in the plasma, such as that generated by anisotropic external heating can generate strong poloidal den…
-
CCFE-PR(15)312015
New experiments in 2013-2014 have investigated the physics responsible for the decrease in H-mode pedestal confinement observed in the initial phase of JET-ILW operation (2012 Experimental Campaigns). The effects of plasma triangularity, global beta and neutrals on pedestal confinement and stability have been investigated systematically. The stabil…
-
CCFE-PR(15)092015
The replacement of the JET carbon wall (C-wall) by a Be/W ITER-like wall (ILW) has affected the plasma energy confinement. To investigate this, experiments have been performed with both the C-wall and ILW to vary the heating power over a wide range for plasmas with different shapes. It was found that the power degradation of thermal energy confinem…
-
CCFE-PR(15)1052015
High spatial resolution Doppler backscattering measurements in JET have enabled new insights into the development of the edge . We observe fine-scale spatial structures in the edge well with a wave number kr ? i ˜ 0.4–0.8, consistent with stationary zonal flows, the characteristics of which vary with density. The zonal flow amplitude and wavelen…
Showing 41 - 50 of 55 UKAEA Paper Results