-
UKAEA-CCFE-PR(20)072019
ELM simulations for the MAST-U Super-X tokamak have been obtained, using the JOREK code. The JOREK visco-resistive MHD model has been used to obtain comparisons of divertor configurations. The simulations show a factor 10 decrease in the peak heat flux to the outer target of the Super-X in comparison to a conventional divertor configuration. A roll…
-
UKAEA-CCFE-CP(19)532019
During edge localised modes (ELMs) high heat fluxes are incident on divertor targets, which future fusion devices will not withstand [1]. A solution to reduce the heat fluxes could be the new Super-X divertor, which will be tested on the MAST-U tokamak. The divertor has an increased connection length, magnetic flux expansion and is designed to reta…
-
UKAEA-CCFE-CP(19)422019
Plasma detachment needs to be achieved in ITER [1] and future devices such as DEMO to dissipate most of the power in the Scrape-Off-Layer (SOL) and reduce the particle flux reaching the divertor targets. In order to enhance our capability to improve current, and design future tokamaks, we must improve our understanding of the relative effect on det…
-
UKAEA-CCFE-PR(19)342019
Reduced models coupled to time-dependent axisymmetric vacuum field calculations are used to develop the prefill and feed-forward coil current targets required for reliable direct induction (DI) startup on the new MA-class spherical tokamaks, MAST-U and NSTX-U. The calculations are constrained by operational limits unique to each device, such as the…
-
CCFE-PR(17)652017
Using high speed imaging of the divertor volume, the region close to the X-point in MAST is shown to be quiescent. This is confirmed by three different analysis techniques and the quiescent X-point region (QXR) spans from the separatrix to the N = 1.02 flux surface. Local reductions to the atomic density and effects associated with the camera vie…
-
CCFE-PR(17)182016
Clear filamentary structures are observed at the edge of tokamak plasmas. These filaments are ejected out radially and carry plasma in the far Scrape Off Layer (SOL) region, where they are responsible for producing most of the transport. A study has been performed of the characteristics of the filaments observed in L-mode plasma on MAST, using visi…
-
CCFE-PR(16)092016
The complete refuelling of the plasma density loss (pump-out) caused by mitigation of Edge Localised Modes (ELMs) is demonstrated on the ASDEX Upgrade tokamak. The plasma is refuelled by injection of frozen deuterium pellets and ELMs are mitigated by external resonant magnetic perturbations (RMPs). In this experiment relevant dimensionless paramete…
-
CCFE-PR(16)302016
In future nuclear fusion reactors high heat load events, such as edge-localised modes (ELMs), can potentially damage divertor materials and release impurities into the main plasma, limiting plasma performance. The most difficult to handle are type I ELMs since they carry the largest fraction of energy from the plasma and therefore deposit the large…
-
CCFE-PR(15)532015
Filamentary transport across the scrape off layer is a key issue for the design and operation of future devices, such as ITER, DEMO and MAST-U, as it sets the power loadings to the divertor and first wall of the machine. Analysis has been performed on L mode filaments in MAST in order to gain an understanding of the spatial structure and attempt to…
-
CCFE-PR(15)522015
SOLPS simulations of MAST-U have been carried out to identify in more detail the physics and operational properties of novel divertor configurations such as Super-X divertor (SXD), in particular the physics of detachment. A well diagnosed L-mode discharge from MAST has been utilised to determine L-mode transport coefficients representative for MAST…
Showing 21 - 30 of 55 UKAEA Paper Results