-
CCFE-PR(15)1282015
The influence of the ITER-like Wall (ILW) with divertor target plate made of tungsten (W), on plasma performance in JET H-mode is being investigated since 2011 (see [1] and references therein). One of the key issues in discharges with low level of D fuelling is observed accumulation of W in the plasma core, which leads to a reduction in plasma perf…
-
CCFE-PR(15)772015
Classical phonon scattering calculations predict the drag force acting on defects and dislocations rises linearly with temperature, in direct contradiction with molecular dynamics simulations that find the drag force to be independent of temperature for nanoscale defects. Using the Mori-Zwanzig projection technique,with no recourse to elasticity or…
-
2015
The transport of particles via intermittent filamentary structures in the private flux region (PFR) of plasmas in the MAST tokamak has been investigated using a fast framing camera recording visible light emission from the volume of the lower divertor, as well as Langmuir probes and IR thermography monitoring particle and power fluxes to plasma-fac…
-
CCFE-PR(15)762015
Ion cyclotron resonance frequency (ICRF) heating has been an essential component in the development of high power H-mode scenarios in JET-ILW. The steps that were taken for the successful use of ICRF heating in terms of enhancing the power capabilities and optimizing the heating performance in view of core impurity mitigation in these experiments w…
-
CCFE-PR(15)1182015
The H-mode pedestal plays an important role in determining global confinement in tokamaks. In high triangularity H-mode experiments in Joint European Torus with the ITER-like wall (JET-ILW), significantly higher pedestal temperature and global confinement have been achieved with nitrogen seeding. The experimentally observed increase in pedestal hei…
-
2014
The core Thomson scattering diagnostic (TS) on the COMPASS tokamak was put in operation and reported earlier. Implementation of edge TS, with spatial resolution along the laser beam up to~1/100 of the tokamak minor radius, is presented now. The procedure for spatial calibration and alignment of both core and edge systems is described. Several furth…
-
2014
Charge exchange spectroscopy has long been a key diagnostic tool for fusion plasmas and is well developed in devices with Carbon Plasma-Facing Components. Operation with the ITER-like wall at JET has resulted in changes to the spectrum in the region of the Carbon charge exchange line at 529.06nm and demonstrates the need to revise the core charge e…
-
2014
In this work we estimate the fuel ion density profile in deuterium plasmas at JET, using the JET neutron camera, the neutron time-of-flight spectrometer TOFOR, and fusion reactivities modeled by the transport code TRANSP. The framework has been tested using synthetic data, which showed that the density profile could be reconstructed with an average…
-
2014
In 2011/12, JET started operation with its new ITER-Like Wall (ILW) made of a tungsten (W) divertor and a beryllium (Be) main chamber wall. The impact of the new wall materials on the JET Ion Cyclotron Resonance Frequency (ICRF) operation is assessed and some important properties of JET plasmas heated with ICRF are highlighted. A 20% reduction of t…
-
2014
In order to preserve the integrity of large tokamaks such as ITER, the number of disruptions has to be limited. JET has operated previously with a low frequency of disruptions (i.e., disruption rate) of 3.4% [P. C. de Vries et al., Nucl. Fusion 51, 053018 (2011)]. The start of operations with the new full-metal ITER-like wall at JET showed a marked…
Showing 181 - 190 of 266 UKAEA Paper Results