-
UKAEA-CCFE-PR(19)112019
Increased neutralisation and hence injected neutral beam power can be achieved by increasing the neutraliser target. This has the potential to increase the loading on the ion source backplate due to backstreaming electrons. Measurements of the backplate power loading due to backstreaming electrons are presented for the JET EP2 neutral beam injector…
-
CCFE-PR(17)392015
In normal operation the JET neutral beam injectors have the operating gas supplied to the ion source and the neutraliser. For tritium operation the gas is supplied to both the ion source and neutraliser at a point close to the earth grid (grid gas) due to the difficulty in producing a gas line with a secondary containment and a ceramic break fo…
-
CCFE-PR(17)262015
For the initial phase of MAST-U operation the two existing neutral beam injection systems will be used, but must be substantially upgraded to fulfil expected operational requirements. The major elements are the design, manufacture and installation of a bespoke bending magnet and Residual Ion Dump (RID) system. The MAST-design full energy dump is b…
-
CCFE-PR(17)232015
We describe the operational experience of the JET actively cooled duct liner and compare it with the previous inertially cooled duct. The paper discusses the initial conditioning of the duct liner during restart commissioning and subsequent high power performance. The new duct was conditioned in 48 plasma pulses during its first time commissioning …
-
CCFE-PR(17)252015
The JET Neutral Beam Injection (NBI) system is the most powerful neutral beam plasma heating system currently operating. Optical Interlocks were installed on the beam lines in 2011 for the JET Enhancement Project 2 (EP2), when the heating power was increased from 23 MW to 34 MW. JET NBI has two beam lines. Each has eight positive ion injectors oper…
-
CCFE-PR(15)1142015
The linear and quasi-linear plasma response to the n = 3 and n = 4 (n is the toroidal mode number) resonant magnetic perturbation (RMP) fields, produced by the in-vessel edge localized mode control coils, is numerically studied for an ITER 15MA H-mode baseline Scenario. Both single fluid and fluid-kinetic hybrid models are used. The inclusion of dr…
-
CCFE-PR(15)1122015
The Small Negative Ion Facility (SNIF) at CCFE has been undergoing continuous development and enhancement to both improve operational reliability and increase diagnostic capability. SNIF uses a CW 13.56MHz, 5kW RF driven volume source with a 30kV triode accelerator. Improvement and characterisation work includes: • Installation of a new “L” t…
-
2014
A significant functional upgrade is planned for the Mega Ampere Spherical Tokamak (MAST) device, located at Culham in the UK, including the implementation of a notably greater neutral beam injection power. This upgrade will cause the emission of a substantially increased intensity of neutron radiation for a substantially increased amount of time up…
-
2014
The three dimensional plasma boundary displacements induced by applied nonaxisymmetric magnetic perturbations have been measured in ASDEX Upgrade, DIII-D, JET, MAST and NSTX. The displacements arising from applied resonant magnetic perturbations (RMPs) are measured up to ±5% of the minor radius in present day machines. Good agreement can be found …
-
2014
The major aspects linked to the use of the JET auxiliary heating systems: NBI, ICRF and LHCD, in the new JET ITER-like wall (JET-ILW) are presented. We show that although there were issues related to the operation of each system, efficient and safe plasma heating was obtained with room for higher power. For the NBI up to 25.7MW was safely injected;…
Showing 11 - 20 of 34 UKAEA Paper Results