UKAEA Journals

Showing 1 - 10 of 16 Journals Results
2019
UKAEA-CCFE-PR(19)78

A new inversion technique is presented for the identification of plasma filaments in wide-angle visible camera data. Direct inversion of camera data onto a field aligned basis is a poorly conditioned problem which is overcome by breaking the analysis into a `psuedo-inversion’ step followed by a `point spread function correction’ step. Camera …

Preprint Published
2017
CCFE-PR(17)68

In many tokamaks ferromagnetic material, usually referred to as an iron-core, is present in order to improve the magnetic coupling between the solenoid and the plasma. The presence of the iron core in proximity to the plasma changes the magnetic topology with consequent e ects on the magnetic field structure and the plasma boundary. This paper cons…

Preprint Purchase
2017
CCFE-PR(17)63

Experiments have been carried out on the MAST and JET tokamaks intended to compare the electrical resistivity of the plasma with theoretical formulations. The tests consist of obtaining motional stark effect (MSE) measurements in MHD-free plasmas during plasma current ramp-up (JET and MAST), ramp-down (MAST) and in stationary state (JET and MAST). …

Preprint Published
2017
CCFE-PR(17)13

Future devices like JT-60SA, ITER and DEMO require quantitative predictions of pedestal density and temperature levels, as well as inter-ELM and ELM divertor heat fluxes, in order to improve global confinement capabilities while preventing divertor erosion/melting in the planning of future experiments. Such predictions can be obtained from dedicate…

Preprint Published
2016
CCFE-PR(16)64

Non-axisymmetric magnetic fields are used to perturbatively probe momentum transport physics in MAST L-mode plasmas. The low beta L-mode target was chosen to complement previous experiments conducted in high beta NSTX H-mode plasmas (ßN=3.5-4.6) where an inward momentum pinch was measured. In those cases quasi-linear gyrokinetic simulations of uns…

Preprint Published
2016
CCFE-PR(17)41

Four numerical codes are employed to investigate the dynamics of Scrape-Off Layer filaments in tokamak relevant conditions. Experimental measurements were taken in the MAST device using visual camera imaging, which allows the evaluation of the perpendicular size and velocity of the filaments, as well as the combination of density and temperature as…

Preprint Published
2016
CCFE-PR(16)19

ELM control may be essential to develop ITER scenarios with a reasonable lifetime of divertor components, whilst ELM pacing may be essential to develop stationary ITER scenarios with a tungsten divertor. Resonant magnetic perturbations (RMPs) have mitigated ELMs in high collisionality plasmas in JET. The efficacy of RMPs in mitigating the ELMs is f…

Preprint Published
2016
CCFE-PR(16)18

A subset of JET ITER-like wall (ILW) discharges, combining electron density and temperature as well as divertor heat flux measurements, has been collected for the validation of non-linear MHD simulations of Edge-Localised-Modes (ELMs). This permits a quantitative comparison of simulation results against experiments, which is required for the valida…

Preprint Published
2016
CCFE-PR(16)79

At the tokamak Joint European Torus (JET), the electron cyclotron emission spectra in O-mode and X-mode polarisations are diagnosed simultaneous in absolute terms for several harmonics with two Martin-Puplett interferometers. From the second harmonic range in X-mode polarisation, the electron temperature profile can be deduced for the outboard side…

Preprint Published
2015
CCFE-PR(15)49

Dust re-suspension as a consequences of LOVA (Loss Of Vacuum Accident) or LOCA (Loss Of Coolant Accident) situations inside a nuclear fusion plant (ITER-like) is an important issue for the workers’ safety and for the security of the plant. The dust size expected inside tokamaks like ITER is of the order of microns (0.1-1000 m m). Analysis of the …

Preprint Purchase