-
UKAEA-CCFE-CP(20)1212020
While current tokamak experiments are beginning to utilise real-time feedback control systems to manage the plasma exhaust, future tokamaks still require validation of theoretical models used to predict the threshold impurity concentration required to facilitate stationary divertor operation. This work exploits new spectroscopic measurements of …
-
2019
Data on erosion and melting of beryllium upper limiter tiles, so-called dump plates (DP), are presented for all three campaigns in the JET tokamak with the ITER-like wall. High-resolution images of the upper wall of JET show clear signs of flash melting on the ridge of the roof-shaped tiles. The melt layers move in the poloidal direction from the i…
-
2018
The first divertor was installed in the JET machine between 1992 and 1994 and was operated with carbon tiles and then beryllium tiles in 1994–5. Post-mortem studies after these first experiments demonstrated that most of the impurities deposited in the divertor originate in the main chamber, and that asymmetric deposition patterns generally favou…
-
UKAEA-CCFE-CP(20)832018
The authors exposed a radiatively cooled, lithium-filled tantalum heat pipe (HP) to a hydrogen plasma in DIFFER’s linear plasma source Magnum PSI continuously for ~2 hours. The beam made a saddle-shaped footprint along the side of the inclined ~195-mm-long HP. During several steps with constant overall heat load, we tilted the HP to vary the peak…
-
UKAEA-CCFE-CP(20)762018
In 1998 Makhankov [1] described the concept of modular exchangeable plasma facing components (PFCs) based on liquid metal heat pipes which are radiatively cooled. Here we present results from recent experiments with a lithium filled tubular heat pipe owned by Sandia National Laboratories. The tantalum envelope (~20mm diameter by ~200mm long) was he…
-
UKAEA-CCFE-PR(20)642018
The JET outboard divertor targets are the in-vessel components which receive the largest heat flux density. Surface delamination, radial cracks, and tie rod failures have been observed in the outboard tungsten-coated CFC tiles, while bulk tungsten special lamellas were intentionally melted in dedicated experiments. These different types of damag…
-
UKAEA-CCFE-CP(19)062019
The next D-T campaign will push JET ITER-like Wall (IWL) to high divertor power and energy levels. During the 2016 campaign, the Strike Point (SP) sweeping permitted relevant H-mode scenarios without exceeding the temperature limits imposed by JET Operation Instructions (JOIs). In the subsequent shutdown, six outer divertor tungsten-coated 2D carbo…
-
UKAEA-CCFE-PR(19)622019
The pedestal structure, ELM losses and linear MHD stability are analysed in a series of JET-ILW H and D type I ELMy H-mode plasmas. The pedestal pressure (pPED) is typically higher in D than in H at the same input power, with the difference mainly due to lower density in H than in D. At the same input power, the pedestal electron pres…
-
CCFE-PR(17)752017
This paper presents the use of a novel modelling technique based around intermittent transport due to filament motion, to interpret experimental profile and fluctuation data in the scrape-off layer (SOL) of JET during the onset and evolution of a density profile shoulder. Three cases are studied at different points in a density ramp experiment wher…
-
CCFE-PR(17)032017
Statistical analysis of the ion flux to the JET outer-wall is conducted in outer-wall limiter mounted Langmuir probe (OLP) time-series across a wide range of plasma current and line-averaged density during Ohmically heated horizontal target L-mode plasmas. The mean, _, and the standard deviation, _, of the ion-saturation current measured by the OLP…
Showing 11 - 20 of 42 UKAEA Paper Results