-
UKAEA-CCFE-PR(25)2892023
This paper reports the first experiment carried out in deuterium–tritium addressing the integration of a radiative divertor for heat-load control with good confinement. Neon seeding was carried out for the first time in a D–T plasma as part of the second D–T campaign of JET with its Be/W wall environment. The technical difficulties linked to …
-
UKAEA-CCFE-PR(25)2882023
Dedicated experiments were performed in JET DTE2 plasmas for obtaining α-particle bump-on-tail (BOT) distribution aiming at exciting Alfvén Eigenmodes (AEs) in baseline tokamak plasma scenario with safety factor q(0)~1. NBI-only heating with modulated power was used so that fusion-born α-particles were the only ions present in the MeV energy ran…
-
UKAEA-CCFE-PR(25)2852023
An overview of the preparation and implementation of the JET DTE2 Safety Case is presented. The Safety Case regime, developed by UKAEA for fusion applications to demonstrate compliance with relevant regulations, and its implementation on UKAEA sites is outlined. The hazard assessment process and details of the methodology applied to assess key J…
-
UKAEA-CCFE-CP(25)042023
2021 has culminated with the completion of the JET-ILW DTE2 experimental campaign. This contribution summarizes Ion Cyclotron Resonance Heating (ICRH) operations from system and physics point of view. Improvements to the (ICRH) system, to operation procedures and to real time RF power control were implemented to address specific constraints from…
-
UKAEA-CCFE-PR(24)2482023
This work describes the usage of Error Field Correction coil system [Barlow I. et al 2001 Fusion Eng. Des. 58-59 189], which is a set of 4 coils located external to the vessel of the JET device, with the aim of introducing non-axisymmetric n=1 magnetic field perturbations in various targeted plasma experiments. Besides being used to characterize…
-
UKAEA-CCFE-PR(24)2472023
The JET hybrid scenario has been developed from low plasma current carbon wall discharges to the record-breaking Deuterium-Tritium plasmas obtained in 2021 with the ITER-like Be/W wall. The development started in pure Deuterium with refinement of the plasma current, and toroidal magnetic field choices and succeeded in solving the heat load challeng…
-
UKAEA-CCFE-PR(24)2462023
Ion Cyclotron wave (IC) assisted breakdown would be important for reducing risks to plasma initiation during the ITER pre-fusion operation phase under difficult vessel conditions. Hence, studies were performed at JET, at ITER relevant loop electric field — and in a regime, and , where plasma breakdown had not previously been achieved on JE…
-
UKAEA-CCFE-PR(24)2452023
2021 JET experimental campaign has produced high stationary fusion power with 50%D 50%T discharges, operated with the ITER-relevant conditions i.e. operation with the baseline or hybrid scenario in the full metallic wall. It has provided a unique opportunity to assess the DT fusion power prediction capability before ITER DT experiments. This pap…
-
UKAEA-CCFE-PR(24)2252023
JET’s frequency-modulated continuous wave (FMCW) reflectometers have been operating well with the current design since 2005 and density profiles are being automatically calculated intershot since then. However, the calculated profiles had long suffered from several shortcomings – poor agreement with other diagnostics; sometimes inappropriate…
-
UKAEA-CCFE-CP(24)102023
The successful realisation of energy production through the fusion of deuterium and tritium will necessarily lead to the generation of waste contaminated with tritium. Not only will some of the tritium fuel permeate into components of fusion reactors and their wider fuel cycle, but tritium will also be generated directly in materials exposed to the…
Showing 51 - 60 of 510 UKAEA Paper Results